• ASTM F1136/F1136M-11(2019)

ASTM F1136/F1136M-11(2019)

Standard Specification for Zinc/Aluminum Corrosion Protective Coatings for Fasteners

ASTM International, 04/01/2019

Publisher: ASTM

File Format: PDF

$21.00$42.00


Published:01/04/2019

Pages:3

File Size:1 file , 69 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the basic requirements for water-based zinc/aluminum dispersion inorganic basecoats and optional sealers and topcoats for fasteners. The basecoat can contain chrome (C) or be non-chrome (NC).

1.2 These coatings are applied by conventional dip-spin, dip-drain, or spray methods to ferrous parts which can be handled through a cleaning, coating, and baking operation, and which are not adversely affected by baking temperatures up to 330 °C [626 °F].

1.3 The coating process does not induce the possibility of internal hydrogen embrittlement providing that the fasteners have not been cleaned or pre-treated with an acid or phosphate. Alkaline cleaning or vapor degreasing is required along with shot blasting to remove rust or scale.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E2019-03(2019)

ASTM E2019-03(2019)

Standard Test Method for Minimum Ignition Energy of a Dust Cloud in Air

$24.00 $48.00

ASTM F1126-12(2017)e1

ASTM F1126-12(2017)e1

Standard Specification for Food Cutters (Electric)

$34.00 $68.00

ASTM Section 14:2015

ASTM Section 14:2015

ASTM Book of Standards - Section 14 - General Methods and Instrumentation (Vols 14.01-14.04)

$142.00 $285.53

ASTM C1546-19

ASTM C1546-19

Standard Guide for Installation of Gypsum Products in Concealed Radiant Ceiling Heating Systems

$22.00 $44.00