Your shopping cart is empty!
ASTM International, 12/01/2013
Publisher: ASTM
File Format: PDF
$32.00$64.00
Published:01/12/2013
Pages:5
File Size:1 file , 220 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method determines the puncture resistance of a protective clothing material specimen by measuring the force required to cause a pointed puncture probe to penetrate through the specimen. This test method describes three protocols that may be used: Method A, Method B, and Method C.
1.1.1 Method A requires the use of Probe A only. The probe used for testing shall be recorded in the test report.
1.1.1.1 Probe A may be used to measure puncture resistance for the following types of materials:
1.1.2 Method B requires the use of Probe B. The probe used for testing shall be recorded in the test report.
1.1.2.1 Probe B may be used to measure puncture resistance for the following types of materials:
1.2 The values stated in SI units are to be regarded as the standard. The values in inch-pound units in brackets are for information purposes only. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Virgin Poly(glycolide) and Poly(glycolide-co-lactide) Resins for Surgical Implants with Mole Fractions Greater Than or Equal to 70% Glycolide
$29.00 $58.00
Standard Specification for Flow Table for Use in Tests of Hydraulic Cement
$30.00 $60.00
Standard Specification for Calcium Silicate Block and Pipe Thermal Insulation
$26.00 $52.00
Standard Specification for Aluminum and Aluminum-Alloy Bar, Rod, and Wire [Metric]
