Your shopping cart is empty!
ASTM International, 10/10/1999
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:10/10/1999
Pages:20
File Size:1 file , 200 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the evaluation of the energy consumption and cooking performance of open, deep fat fryers. The food service operator can use this evaluation to select a fryer and understand its energy efficiency and production capacity.
1.2 This test method is applicable to floor model gas and electric units with 35- to 60-lb frying medium capacity.
1.3 The fryer can be evaluated with respect to the following (where applicable):
1.3.1 Energy input rate (10.2),
1.3.2 Preheat energy and time (10.4),
1.3.3 Idle energy rate (10.5),
1.3.4 Pilot energy rate (10.6),
1.3.5 Cooking energy rate and efficiency (10.10), and
1.3.6 Production capacity and frying medium temperature recovery time (10.10).
1.4 This test method is not intended to answer all performance criteria in the evaluation and selection of a fryer, such as the significance of a high energy input design on maintenance of temperature within the cooking zone of the fryer.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Ozone-Resistant Ethylene-Alkene Polymer Insulation for Wire and Cable
$26.00 $52.00
Standard Practice for Determining Effect of Packaging on Food and Beverage Products During Storage
Standard Test Method for Separation and Collection of Particulate and Gaseous Fluorides in the Atmosphere (Sodium Bicarbonate-Coated Glass Tube and Particulate Filter Method)
$30.00 $60.00
Standard Test Method for Flexibility Determination of Hot-Melt Adhesives by Mandrel Bend Test Method