Your shopping cart is empty!
ASTM International, 07/01/2012
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/07/2012
Pages:4
File Size:1 file , 120 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method establishes a procedure for comparing the elemental composition of normal surfaces with any defects found on the surfaces of metal tubing, fittings, valves, or any metal component.
1.2 This test method applies to all steel surfaces of components such as tubings, connectors, regulators, and valves, regardless of size, style, or type.
1.3 Limitations:
1.3.1 This test method is intended for use by scanning electron microscope/energy dispersive x-ray spectrometer (SEM/EDX) operators with skill level typically achieved over a twelve-month period.
1.3.2 SEM used for this study should conform to those limitations outlined in Test Method F1372 and should have a minimum point-to-point resolution of 30 nm.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6.
Standard Test Method for Detection of Holes in Medical Gloves
$26.00 $52.00
Standard Practice for Minimum Structural Design Loading for Monolithic or Sectional Precast Concrete Water and Wastewater Structures
$30.00 $60.00
ASTM Volume 04.06 Thermal Insulation; Building and Environmental Acoustics
$138.00 $276.90
Standard Test Method for Sodium in Residual Fuel Oil (Flame Photometric Method)
