• ASTM F1380-95a(2002)

ASTM F1380-95a(2002)

Standard Specification for Metal Insert Fittings for Polybutylene (PB) Tubing

ASTM International, 01/01/2002

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/2002

Pages:6

File Size:1 file , 65 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers metal insert fittings for polybutylene (PB) plastic tubing. These fittings are intended for use in 100 psi (6.9 MPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for materials, workmanship, burst pressure, sustained pressure, temperature cycling tests, and markings to be used on the fittings.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values stated in parentheses are provided for information purposes.

1.3 The following precautionary caveat pertains only to the test method portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E6-23

ASTM E6-23

Standard Terminology Relating to Methods of Mechanical Testing

$38.00 $76.00

ASTM D996-23

ASTM D996-23

Standard Terminology of Packaging and Distribution Environments

$31.00 $63.00

ASTM B696-00(2023)

ASTM B696-00(2023)

Standard Specification for Coatings of Cadmium Mechanically Deposited

$28.00 $57.00

ASTM E3026-23e1

ASTM E3026-23e1

Standard Guide for Readily Observable Moisture Affected Materials and Conditions Conducive to Elevated Moisture in Commercial Buildings: Limited Moisture Assessment Process

$41.00 $82.00