Your shopping cart is empty!
ASTM International, 01/01/2002
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/01/2002
Pages:6
File Size:1 file , 68 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers metal insert fittings for polybutylene (PB) plastic tubing. These fittings are intended for use in 100 psi (6.9 MPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for materials, workmanship, burst pressure, sustained pressure, temperature cycling tests, and markings to be used on the fittings.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values stated in parentheses are provided for information purposes.
1.3 The following precautionary caveat pertains only to the test method portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Calibration of a Spectroradiometer Using a Standard Source of Irradiance
$25.00 $50.00
Standard Test Method for Determining Dynamic Air Permeability of Inflatable Restraint Fabrics
$29.00 $58.00
Standard Guide for Design, Fabrication, and Erection of Fiberglass Reinforced (FRP) Plastic Chimney Liners with Coal-Fired Units
$36.00 $72.00
Standard Test Method for Measuring the Coefficient of Retroreflected Luminance (RL) of Pavement Markings in a Standard Condition of Wetness
$31.00 $62.00