Your shopping cart is empty!
ASTM International, 04/15/2020
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:15/04/2020
Pages:8
File Size:1 file , 310 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers a procedure for testing components for oxygen contribution to ultra-high purity gas distribution systems at ambient temperature. In addition, this test method allows testing of the component at elevated ambient temperatures as high as 70°C.
1.2 This test method applies to in-line components containing electronics grade materials such as those used in a semiconductor gas distribution system.
1.3 Limitations:
1.3.1 This test method is limited by the sensitivity of current instrumentation, as well as the response time of the instrumentation. This test method is not intended to be used for test components larger than 12.7-mm (1/2-in.) outside diameter nominal size. This test method could be applied to larger components; however, the stated volumetric flow rate may not provide adequate mixing to ensure a representative sample. Higher flow rates may improve the mixing but excessively dilute the sample.
1.3.2 This test method is written with the assumption that the operator understands the use of the apparatus at a level equivalent to six months of experience.
1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 5.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Nickel Alloy Billets and Bars for Reforging
$26.00 $52.00
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation
$30.00 $60.00
Standard Terminology Relating to Petroleum, Petroleum Products, and Lubricants
$52.00 $104.00
Standard Test Method for 2,6-di-tert-Butyl- p-Cresol and 2,6-di-tert-Butyl Phenol in Electrical Insulating Oil by Infrared Absorption
$32.00 $64.00
