Your shopping cart is empty!
ASTM International, 06/01/2019
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/06/2019
Pages:15
File Size:1 file , 800 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method measures cut resistance of garments and devices worn to protect the lower body (legs) when operating a chainsaw.
1.2 This test method may be used to test for compliance to minimum performance requirements in established safety standards.
1.2.1 By agreement between the purchaser and the supplier, or as required by established safety standards, it will be decided if this test method will be used to determine one or both of the following: (1) chain speed 50 (CS50), and (2) success/failure (jamming/chain stop or no cut in less than 1.5 s) at specified chain speed.
1.3 This test method may be used to determine levels of protection for areas of coverage as stipulated in established safety standards.
1.4 The values stated in SI units are to be regarded as standard.
Note 1: The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for In-Plane Length Measurements of Thin, Reflecting Films Using an Optical Interferometer
$32.00 $65.00
Standard Practice for Statistical Assessment and Improvement of the Expected Agreement Between Two Test Methods that Purport to Measure the Same Property of a Material
$33.00 $67.00
Standard Specification for Copper Alloy Permanent Mold Castings for General Applications
$26.00 $52.00
Standard Test Method for Determination of Decay Rates for Use in Sound Insulation Test Methods
$25.00 $50.00
