• ASTM F1588-96(2015)

ASTM F1588-96(2015)

Standard Test Method for Constant Tensile Load Joint Test (CTLJT)

ASTM International, 08/01/2015

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/08/2015

Pages:4

File Size:1 file , 77 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 The constant tensile load joint test (CTLJT) is designed to demonstrate that a joint in a plastic piping system is resistant to the effects of long-term creep.

1.1.1 The joint is subjected to an internal pressure at least equal to its operating pressure and a sustained axial tensile load for a specified time period, usually 1000 h. The joint shall not leak, nor may the pipe completely pull out for the test duration. The total axial stress is set by the referencing document.

1.1.2 Some typical conditions for testing of joints on polyethylene pipe are described in Appendix X1.

1.2 This test is usually performed at 73°F (22.8°C).

1.3 The CTLJT was developed to demonstrate the long-term resistance to pullout of mechanical joints on polyethylene gas pipe. The CTLJT has also been successfully applied to the evaluation of other components of plastic piping systems. These applications are discussed in Appendix X1.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D6117-23

ASTM D6117-23

Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

$28.00 $57.00

ASTM C1600/C1600M-23

ASTM C1600/C1600M-23

Standard Specification for Rapid Hardening Hydraulic Cement

$28.00 $57.00

ASTM D6750-23

ASTM D6750-23

Standard Test Methods for Evaluation of Engine Oils in a High-Speed, Single-Cylinder Diesel Engine—1K Procedure (0.4 % Fuel Sulfur) and 1N Procedure (0.04 % Fuel Sulfur)

$47.00 $95.00

ASTM C187-23

ASTM C187-23

Standard Test Method for Amount of Water Required for Normal Consistency of Hydraulic Cement Paste

$25.00 $50.00