• ASTM F1711-96

ASTM F1711-96

Standard Practice for Measuring Sheet Resistance of Thin Film Conductors for Flat Panel Display Manufacturing Using a Four-Point Probe

ASTM International, 01/01/1996

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/1996

Pages:8

File Size:1 file , 85 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes methods for measuring the sheet electrical resistance of sputtered thin conductive films deposited on large insulating substrates, used in making flat panel information displays. It is assumed that the thickness of the conductive thin film is much thinner than the spacing of the contact probes used to measure the sheet resistance.

1.2 This standard is intended to be used with Test Method F 390.

1.3 Sheet resistively in the range of 0.5 to 5000 ohms per square may be measured by this practice. The sheet resistance is assumed uniform in the area being probed.

1.4 This practice is applicable to flat surfaces only.

1.5 Probe pin spacings of 1.5 mm to 5.0 mm, inclusive (0.059 to 0.197in. inclusive) are covered by this practice.

1.6 The method in this practice is potentially destructive to the thin film in the immediate area in which the measurement is made. Areas tested should thus be characteristic of the functional part of the substrate, but should be remote from critical active regions. The method is suitable for characterizing dummy test substrates processed at the same time as substrates of interest.

1.7 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM C1135-19

ASTM C1135-19

Standard Test Method for Determining Tensile Adhesion Properties of Structural Sealants

$21.00 $42.00

ASTM D3987-12(2020)

ASTM D3987-12(2020)

Standard Practice for Shake Extraction of Solid Waste with Water

$22.00 $44.00

ASTM F2101-22

ASTM F2101-22

Standard Test Method for Evaluating the Bacterial Filtration Efficiency (BFE) of Medical Face Mask Materials, Using a Biological Aerosol of Staphylococcus aureus

$34.00 $68.00

ASTM D5983-21

ASTM D5983-21

Standard Specification for Methyl Tertiary-Butyl Ether (MTBE) for Blending With Gasolines for Use as Automotive Spark-Ignition Engine Fuel

$23.00 $46.00