• ASTM F1743-21

ASTM F1743-21

Standard Practice for Rehabilitation of Existing Pipelines and Conduits by Pulled-in-Place Installation of Cured-in-Place Thermosetting Resin Pipe (CIPP)

ASTM International, 10/31/2021

Publisher: ASTM

File Format: PDF

$34.00$68.00


Published:31/10/2021

Pages:8

File Size:1 file , 160 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This practice describes the procedures for the reconstruction of pipelines and conduits (2'''in. to 96 in. (5'''cm to 244 cm) diameter) by the pulled-in-place installation of a resin-impregnated, flexible fabric tube into an existing conduit and secondarily inflated through the inversion of a calibration hose by the use of a hydrostatic head or air pressure (see Fig. 1). The resin is cured by circulating hot water, by the introduction of controlled steam into the tube, or by photoinitiated reaction. When cured, the finished cured-in-place pipe will be continuous and tight fitting. This reconstruction process may be used in a variety of gravity and pressure applications such as sanitary sewers, storm sewers, process piping, electrical conduits, and ventilation systems.

FIG. 1 Cured-in-Place Pipe Installation Methods

 Cured-in-Place Pipe Installation Methods Cured-in-Place Pipe Installation Methods

1.2''The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Note 1:''There are no ISO standards covering the primary subject matter of this practice.

1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D971-91

ASTM D971-91

Standard Test Method for Interfacial Tension of Oil Against Water by the Ring Method

$21.00 $43.20

ASTM D4175-02ae2

ASTM D4175-02ae2

Standard Terminology Relating to Petroleum, Petroleum Products, and Lubricants

$44.00 $89.00

ASTM B609M-97

ASTM B609M-97

Standard Specification for Aluminum 1350 Round Wire, Annealed and Intermediate Tempers, for Electrical Purposes [Metric] (Withdrawn 1999)

$26.00 $52.00

ASTM D6825-02e1

ASTM D6825-02e1

Standard Guide for Placement of Riprap Revetments

$30.00 $60.00