Your shopping cart is empty!
ASTM International, 04/01/2017
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:01/04/2017
Pages:23
File Size:1 file , 1.2 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers an evaluation of the energy consumption and cooking performance of conveyor ovens. The food service operator can use this evaluation to select a conveyor oven and understand its energy consumption.
1.2 This test method is applicable to gas and electric conveyor ovens.
1.3 The conveyor oven can be evaluated with respect to the following (where applicable):
1.3.1 Energy input rate and thermostat calibration (see 10.2),
1.3.2 Preheat energy consumption and time (see 10.3),
1.3.3 Idle energy rate (see 10.4),
1.3.4 Pilot energy rate (if applicable) (see 10.5), and
1.3.5 Cooking energy efficiency and production capacity (see 10.6).
1.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This test method may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for As-Welded Wrought Austenitic Stainless Steel Fittings for General Corrosive Service at Low and Moderate Temperatures
$26.00 $52.00
Standard Test Method for Distillation of Industrial Aromatic Hydrocarbons and Related Materials
$30.00 $60.00
Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing (Small-Diameter) for General Service
Standard Test Method for Crack Strength of Slow-Bend Precracked Charpy Specimens of High-Strength Metallic Materials (Withdrawn 2005)
$25.00 $50.00