Your shopping cart is empty!
ASTM International, 11/01/2017
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:01/11/2017
Pages:17
File Size:1 file , 210 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the energy consumption and cooking performance of large-vat open, deep fat fryers. The food service operator can use this evaluation to select a fryer and understand its energy efficiency and production capacity.
1.2 This test method is applicable to floor model gas and electric fryers with 50 lb (23 kg) and greater fat capacity and an 18-in. and larger vat size.
1.3 The fryer can be evaluated with respect to the following (where applicable):
1.3.1 Energy input rate (10.2),
1.3.2 Preheat energy and time (10.4),
1.3.3 Idle energy rate (10.5),
1.3.4 Pilot energy rate (10.6, if applicable),
1.3.5 French fry cooking energy rate and efficiency (10.9),
1.3.6 French fry production capacity and frying medium temperature recovery time (10.9),
1.4 This test method is not intended to answer all performance criteria in the evaluation and selection of a fryer, such as the significance of a high energy input design on maintenance of temperature within the cooking zone of the fryer.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Measurement of Mechanical Properties During Charged-Particle Irradiation
$30.00 $60.00
Standard Specification for Cylindrical Sealant Backing for Use with Cold Liquid-Applied Sealants
Standard Test Methods for Volatile Loss From Plastics Using Activated Carbon Methods
$26.00 $52.00
Standard Specification for Seamless and Welded Ferritic/Austenitic Stainless Steel Pipe