• ASTM F2181-20

ASTM F2181-20

Standard Specification for Wrought Seamless Stainless Steel Tubing for Surgical Implants

ASTM International, 06/01/2020

Publisher: ASTM

File Format: PDF

$26.00$52.00


Published:01/06/2020

Pages:5

File Size:1 file , 89 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the requirements for five compositions of wrought seamless stainless steel tubing for the manufacture of surgical implants. Material shall conform to the applicable requirements of Specification F138, F1314, F1586, F2229, or F2581. This specification addresses those product variables that differentiate wrought seamless tubing from the bar and wire product forms covered in these specifications.

1.2 This specification applies to cold finished, straight length tubing from 3 to 34 mm [0.125 to 1.315 in.] nominal outside diameter (OD) and 0.5 mm [0.020 in.] and greater nominal wall thickness.

1.3 The specifications in 2.1 are referred to as the ASTM material standard(s) in this specification.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other and values from the two systems shall not be combined.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F2861-17

ASTM F2861-17

Standard Test Method for Enhanced Performance of Combination Oven in Various Modes

$34.00 $69.00

ASTM D6465-99

ASTM D6465-99

Standard Guide for Selecting Aerospace and General Purpose Adhesives and Sealants

$29.00 $58.00

ASTM D5275-11

ASTM D5275-11

Standard Test Method for Fuel Injector Shear Stability Test (FISST) for Polymer Containing Fluids

$30.00 $60.00

ASTM D6576-13

ASTM D6576-13

Standard Specification for Flexible Cellular Rubber Chemically Blown

$30.00 $60.00