• ASTM F2306/F2306M-20

ASTM F2306/F2306M-20

Standard Specification for 12 to 60 in. [300 to 1500 mm] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Gravity-Flow Storm Sewer and Subsurface Drainage Applications

ASTM International, 11/01/2020

Publisher: ASTM

File Format: PDF

$32.00$64.00


Published:01/11/2020

Pages:10

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This specification covers requirements and test methods for annular, corrugated profile wall polyethylene pipe and fittings with an interior liner. The nominal inside diameters covered are 12 to 60 in. [300 to 1500 mm].

1.2''The requirements of this specification are intended to provide pipe and fittings for underground use for gravity-flow storm sewer and subsurface drainage systems.

Note 1:''Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321.

1.3''This specification covers pipe and fittings with an interior liner using a corrugated exterior profile (Fig. 1).

FIG. 1''Typical Annular Corrugated Pipe Profile

Typical Annular Corrugated Pipe ProfileTypical Annular Corrugated Pipe Profile

1.4''The products manufactured under this standard use either virgin or recycled (post-industrial or post-consumer) materials in accordance with the requirements specified for each.

1.5''Units'''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6''The following precautionary caveat pertains only to the test method portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F816-83(2003)

ASTM F816-83(2003)

Standard Test Method for Combined Fine and Gross Leaks for Large Hybrid Microcircuit Packages (Withdrawn 2009)

$25.00 $50.00

ASTM D3643-15

ASTM D3643-15

Standard Test Method for Acid Number of Certain Alkali-Soluble Resins

$30.00 $60.00

ASTM F875-94(2003)

ASTM F875-94(2003)

Standard Test Method for Evaluation of Large Area Density and Background on Office Copiers

$25.00 $50.00

ASTM D4213-08(2012)

ASTM D4213-08(2012)

Standard Test Method for Scrub Resistance of Paints by Abrasion Weight Loss

$30.00 $60.00