• ASTM F2317/F2317M-05

ASTM F2317/F2317M-05

Standard Specification for Design of Weight-Shift-Control Aircraft

ASTM International, 11/01/2005

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/11/2005

Pages:10

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the minimum airworthiness standards a manufacturer shall meet in the designing, testing, and labeling of weight-shift-control aircraft.

1.2 This specification covers only weight-shift-control aircraft in which flight control systems do not use hinged surfaces controlled by the pilot.

Note 1

This section is intended to preclude hinged surfaces such as typically found on conventional airplanes such as rudders and elevators. Flexible sail surfaces typically found on weight-shift aircraft are not considered hinged surfaces for the purposes of this specification.

1.3 Weight-shift-control aircraft means a powered aircraft with a framed pivoting wing and a fuselage (trike carriage) controllable only in pitch and roll by the pilot's ability to change the aircraft's center of gravity with respect to the wing. Flight control of the aircraft depends on the wing's ability to flexibly deform rather than the use of control surfaces.

1.4 This specification is organized and numbered in accordance with the bylaws established for Committee F37. The main sections are:

Scope
Referenced Documents
Terminology
Flight Requirements
Structural Requirements
Design and Construction Requirements
Powerplant Requirements
Equipment Requirements
Operating Limitations
Keywords
Annex
Appendix

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

More ASTM standard pdf

ASTM F3522-22

ASTM F3522-22

Standard Guide for Additive Manufacturing of Metals — Feedstock Materials — Assessment of Powder Spreadability

$28.00 $57.00

ASTM D6437-05(2010)e1

ASTM D6437-05(2010)e1

Standard Test Method for Polyurethane Raw Materials: alkalinity in Low-Alkalinity Polyols (Determination of CPR values of Polyols)

$26.00 $52.00

ASTM B824-16

ASTM B824-16

Standard Specification for General Requirements for Copper Alloy Castings

$29.00 $58.00

ASTM D1793-17

ASTM D1793-17

Standard Test Method for Water Spotting of Emulsion Floor Polishes

$21.00 $42.00