Your shopping cart is empty!
ASTM International, 06/01/2013
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/06/2013
Pages:5
File Size:1 file , 89 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners. It also provides for minor coating repairs. Nails and rivets are not included in this specification.
1.2 It is intended to be applicable to fasteners that are centrifuged or otherwise handled to remove excess galvanizing bath metal (free zinc).
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Terminology for F16 Mechanical Fasteners
$32.00 $65.00
Standard Test Method for Rubber Properties-Measurement of Cure and After-Cure Dynamic Properties Using a Rotorless Shear Rheometer
$33.00 $67.00
Standard Guide for Performance of an Ice Rescuer--Level II
$28.00 $56.00
Standard Specification for Epoxy Molding Compounds
$26.00 $52.00
