ASTM F2803-21

1.1''This test method is performed to determine the amount of rotational slip occurring at the tire/wheel interface while under heavy longitudinal load conditions.

1.2''This test method is suitable for research and development purposes where tires are compared during a single series of tests. They may not be suitable for regulatory statutes or specification acceptance because the values obtained may not necessarily agree or correlate either in rank order or absolute performance level with those obtained under other environmental conditions on other surfaces or the same surface after additional use.

1.3''The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.