ASTM F2811-10

1.1 These test methods specify procedures and equipment used for testing and evaluating elliptical trainers for compliance to Specification . Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In case of a conflict between this document and Specification , Specification takes precedence.

1.2 Requirements - An elliptical trainer is to be tested for all of the following parameters:

1.2.1 Endurance,

1.2.2 Static loading,

1.2.2.1 Handlebars

1.2.2.2 Foot supports

1.2.3 Adjustable guide systems,

1.2.4 Control panel,

1.2.5 Warnings, and

1.2.6 Documentation.

1.3 The values stated in SI units are to be regarded as the standard. The values in parenthesis are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.