Your shopping cart is empty!
ASTM International, 05/01/2021
Publisher: ASTM
File Format: PDF
$32.00$64.00
Published:01/05/2021
Pages:8
File Size:1 file , 140 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This specification covers requirements and test methods for dual wall polypropylene pipe and fittings. The nominal inside diameters covered are 12 to 60 in. [300 to 1500 mm].
1.2''The requirements of this specification are intended to provide pipe and fittings suitable for underground use for non-pressure storm sewer systems. Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321.
1.3''This specification covers pipe and fittings with an interior smooth wall and an annular corrugated profile outer wall (Fig. 1).
FIG. 1''Interior Smooth Wall and an Annular Corrugated Profile Outer Wall
1.4''Units'''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5''The following precautionary statement caveat pertains only to the test method portion, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Tuft Element Length of Uncoated Pile Yarn Floor Coverings
$27.00 $54.00
Standard Test Method for Transition Temperatures and Enthalpies of Fusion and Crystallization of Polymers by Differential Scanning Calorimetry
$30.00 $60.00
Standard Test Method for Discrimination Between Flammability Ratings of F = 0 and F = 1
$26.00 $52.00
Standard Guide for Soil Gas Monitoring in the Vadose Zone (Withdrawn 2015)
$43.00 $86.00