• ASTM F2931-16

ASTM F2931-16

Standard Guide for Analytical Testing of Substances of Very High Concern in Materials and Products

ASTM International, 07/01/2016

Publisher: ASTM

File Format: PDF

$60.00$120.00


Published:01/07/2016

Pages:105

File Size:1 file , 520 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide contains a list of potential test methods for the analysis of Substances of Very High Concern (SVHC) as designated by ECHA, the European Chemicals Agency. Information on the test methods cited is publicly available and is drawn from a variety of sources. The guide is intended to assist in the selection of test methods that are applicable for the SVHCs identified.

1.2 The specific SVHCs covered within this guide are compiled from the ECHA Candidate List of Substances of Very High Concern. This list is also referred to as the REACH Candidate List.

1.3 This guide specifically addresses methods for the analysis of SVHCs in products. It is not intended to cover the many and varied analysis challenges associated in the manufacturing environment.

1.4 Limitations: 

1.4.1 This guide is intended to provide a compilation of available test methods for the SVHCs listed on the ECHA Candidate list and is not intended to be exhaustive. The test methods within this guide are not the only ones available for any specific substances and this guide does not recommend any specific test method.

1.4.2 Test methods for specific substances at the detection limits required for REACH reporting are not always available. In some cases, it is necessary to deduce the quantity of substance present through the analysis and quantification of its elements. Although this approach is routinely used some degree of uncertainty exists in the final result due to the reduced specificity of the test method.

1.4.3 Although this guide is intended to be updated on a periodic basis to capture new developments in the field, there is no assurance that the information provided is the most current.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E555-95

ASTM E555-95

Practice for Determining Acute Oral LD50 for Testing Vertebrate Control Agents (Withdrawn 2000)

$25.00 $50.00

ASTM D4801-95

ASTM D4801-95

Standard Specification for Polyethylene Sheeting in Thickness of 0.25 mm (0.010 in.) and Greater

$25.00 $50.00

ASTM D2454-95

ASTM D2454-95

Standard Practice for Determining the Effect of Overbaking on Organic Coatings

$25.00 $50.00

ASTM D2561-95(2001)

ASTM D2561-95(2001)

Standard Test Method for Environmental Stress-Crack Resistance of Blow-Molded Polyethylene Containers

$30.00 $60.00