Your shopping cart is empty!
ASTM International, 06/01/2012
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:01/06/2012
Pages:7
File Size:1 file , 220 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers basic characteristics required for porous laminated phenolic materials intended for use as instrument and thin-section ball-bearing retainers (cages) and the methods of determining these characteristics.
1.2 Forms - Sheets, rolled tubes, molded tubes, and rods are recommended forms of laminated material covered by this specification.
1.3 Intended Use - Materials produced to this specification are intended for use as ball-bearing retainers (cages). Temperature range is limited to 250°F (117°C) and below.
1.4 Units - The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Alternating-Current Magnetic Properties of Materials at Power Frequencies Using Wattmeter-Ammeter-Voltmeter Method and 25-cm Epstein Test Frame
$32.00 $65.00
Standard Specification for Installation of Cast-In-Place Reinforced Gypsum Concrete
$30.00 $60.00
Standard Specification for Drain, Waste, and Vent (DWV) Plastic Fittings Patterns
$41.00 $83.00
Standard Test Method for Alkali Resistance of Porcelain Enamels
