• ASTM F2978-13

ASTM F2978-13

Guide to Optimize Scan Sequences for Clinical Diagnostic Evaluation of Metal-on-Metal Hip Arthroplasty Devices using Magnetic Resonance Imaging

ASTM International, 12/01/2013

Publisher: ASTM

File Format: PDF

$31.00$62.00


Published:01/12/2013

Pages:9

File Size:1 file , 370 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide describes the recommended protocol for magnetic resonance imaging (MRI) studies of patients implanted with metal-on-metal (MOM) devices to determine if the periprosthetic tissues are likely to be associated with an adverse local tissue reaction (ALTR). Before scanning a patient with a specific implant, the MR practitioner shall confirm that the device is MR Conditional and that the scan protocol to be used satisfies the conditions for safe scanning for the specific implant. This guide assumes that the MRI protocol will be applied to MOM devices while they are implanted inside the body. It is also expected that standardized MRI safety measures will be followed during the performance of this scan protocol.

1.2 This guide covers the clinical evaluation of the tissues surrounding MOM hip replacement devices in patients using MRI. This guide is applicable to both total and resurfacing MOM hip systems.

1.3 The protocol contained in this guide applies to whole body magnetic resonance equipment, as defined in section 2.2.103 of IEC 60601-2-33, Ed. 3.0, with a whole body radiofrequency (RF) transmit coil as defined in section 2.2.100. The RF coil should have quadrature excitation.

1.4 The values stated in SI units are to be regarded as standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The user may consider all precautions and warnings provided in the MR system and hip implant labeling prior to determining the applicability of these protocols.

More ASTM standard pdf

ASTM D6416/D6416M-01e1

ASTM D6416/D6416M-01e1

Standard Test Method for Two-Dimensional Flexural Properties of Simply Supported Sandwich Composite Plates Subjected to a Distributed Load

$33.00 $67.00

ASTM D3555-01

ASTM D3555-01

Standard Specification for Track-Resistant Black Crosslinked Polyethylene Insulation for Wire and Cable, 90oC Operation

$26.00 $52.00

ASTM D5191-99

ASTM D5191-99

Standard Test Method for Vapor Pressure of Petroleum Products (Mini Method)

$29.00 $58.00

ASTM D178-01e1

ASTM D178-01e1

Standard Specification for Rubber Insulating Matting

$30.00 $60.00