Your shopping cart is empty!
ASTM International, 07/01/2015
Publisher: ASTM
File Format: PDF
$34.00$68.00
Published:01/07/2015
Pages:10
File Size:1 file , 390 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load using the Tomodynamometer (TDM-100).
1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting.
1.1.2 Test apparatus may have limitations in testing materials with a thickness greater than 20 mm.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Conditioning Containers, Packages, or Packaging Components for Testing
$26.00 $52.00
Standard Specification for Refined Iridium
$28.00 $56.00
Standard Specification for Asbestos-Cement Flat Sheet for Cooling Tower Fill
Standard Practice for Measuring Payback for Investments in Buildings and Building Systems
$29.00 $58.00
