Your shopping cart is empty!
ASTM International, 07/15/2013
Publisher: ASTM
File Format: PDF
$33.00$67.00
Published:15/07/2013
Pages:11
File Size:1 file , 480 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This practice establishes requirements and considerations for the numerical simulation of non-modular (that is, limited to monolithic stems with only a femoral head / trunnion taper interface) metallic orthopaedic hip stems using Finite Element Analysis (FEA) techniques for the estimation of stresses and strains. This standard is only applicable to stresses below the yield strength, as provided in the material certification.
1.2 Purpose-This practice establishes requirements and considerations for the development of finite element models to be used in the evaluation of non-modular metallic orthopaedic hip stem designs for the purpose of prediction of the static implant stresses and strains. This procedure can be used for worst case assessment within a family of implant sizes to provide efficiencies in the amount of physical testing to be conducted. Recommended procedures for performing model checks and verification are provided to help determine if the analysis follows recommended guidelines. Finally, the recommended content of an engineering report covering the mechanical simulation is presented.
1.3 Limits-This practice is limited in discussion to the static structural analysis of non-modular metallic orthopaedic hip stems (which excludes the prediction of fatigue strength).
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Transverse Tensile Properties of Hoop Wound Polymer Matrix Composite Cylinders
$30.00 $60.00
Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between -;30 oC and 30 oC with a Vitreous Silica Dilatometer
$31.00 $62.00
Standard Test Method for Microcellular Urethanes--Flexural Recovery
$26.00 $52.00
Standard Test Method for Stability of Perchloroethylene with Copper
