• ASTM F3110-14(2018)

ASTM F3110-14(2018)

Standard Practice for Proper Use of Mechanical Trenchless Point Repair Sleeve with Locking Gear Mechanism for Pipes of Varying Inner Diameter and Offset Joints

ASTM International, 08/01/2018

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/08/2018

Pages:14

File Size:1 file , 280 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice establishes minimum requirements for good practices for the materials and installation of mechanical trenchless repair sleeve with a locking gear mechanism for pipes of varying inner diameter and offset joints in the range of 6 to 72 in. (150 to 1800 mm).

1.2 This practice applies to storm, potable water, wastewater and industrial pipes, conduits and drainage culverts.

1.3 When the specified materials are used in manufacturing the sleeve and installed in accordance with this practice, the sleeve shall extend over a predetermined length of the host pipe as a continuous, tight fitting, corrosion resistant and verifiable non-leaking pipe repaired using one or more pieces of the repair sleeve mechanism. The maximum internal pressure this sleeve can carry depends on the diameter and the wall thickness, ranging from 10 to 15 bars; the external pressure shall not exceed 1.5 bars.

1.4 All materials in contact with potable water shall be certified to meet NSF/ANSI 61/372.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Particular attention is drawn to those safety regulations and requirements involving entering into and working in confined spaces.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F2493-18

ASTM F2493-18

Standard Specification for P225/60R16 97S Radial Standard Reference Test Tire

$26.00 $52.00

ASTM F2689-08

ASTM F2689-08

Standard Practice for Design and Manufacture of Reciprocating Spark Ignition Engines for Unmanned Aircraft Systems (Withdrawn 2014)

$25.00 $50.00

ASTM C732-17

ASTM C732-17

Standard Test Method for Aging Effects of Artificial Weathering on Latex Sealants

$28.00 $56.00

ASTM D2416-84(2015)e1

ASTM D2416-84(2015)e1

Standard Test Method for Coking Value of Tar and Pitch (Modified Conradson)

$26.00 $52.00