Your shopping cart is empty!
ASTM International, 05/01/2015
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/05/2015
Pages:8
File Size:1 file , 100 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers procedures for the analysis of tin-based solder alloys for minor and trace elements using inductively-coupled plasma atomic emission spectrometry (ICP-AES) instrumentation.
1.2 These test procedures were validated for the analytes and mass fractions listed below.
Element
Validated Mass Fraction Range, mg/kg
Lead
115 to 965
Cadmium
25 to 60
Mercury
5 to 530
Antimony
85 to 1330
Bismuth
80 to 210
Arsenic
95 to 360
Silver
4000 to 42100
Cobalt
0.5 to 60
Iron
15 to 115
Chromium
0.5 to 1.5
Copper
3000 to 30600
Indium
25 to 115
Nickel
5 to 150
Phosphorus
10 to 110
Selenium
1 to 30
Zinc
2 to 160
Aluminum
1 to 3
1.3 The procedures appear in the following order:
Procedure
Section
Internal Standardization
8
Calibration Solution Preparations
9
Preparation of Sample and Validation Solutions
10
Calibration
11
Analysis Procedure
12
1.4 The values stated in SI units are to be regarded as the standard. Any other values are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Method for Stability of Water-in-Oil Emulsions Under Low to Ambient Temperature Cycling Conditions
$25.00 $50.00
Standard Test Methods for Concrete Pipe, Manhole Sections, or Tile (Metric)
$32.00 $65.00
Standard Test Method for Hot Spot Protection Testing of Photovoltaic Modules
$34.00 $68.00
Standard Specification for Pedestrian and Light Traffic Paving Brick
$26.00 $52.00
