• ASTM F3218-17

ASTM F3218-17

Standard Practice for Recording Environmental Effects for Utilization with A-UGV Test Methods

ASTM International, 07/01/2017

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/07/2017

Pages:9

File Size:1 file , 550 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes a means to record the following environmental conditions that may affect the performance of A-UGVs: lighting, external sensor emission, temperature, ground surface, air quality, humidity, and electrical interference.

1.2 The A-UGV operating ranges for each of the conditions listed in 1.1 are described and parameterized in Section 4 and allow a basis for performance comparison in test methods. The approach is to divide the list of environmental conditions into sub-conditions that represent the various aspects of the major category (for example, sunlight within ambient lighting). Where necessary, this practice also provides guidelines (for example, lighting direction) to record environmental conditions in an existing environment.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are not precise mathematical conversion to imperial units. They are close approximate equivalents for the purpose of specifying material dimensions or quantities that are readily available to avoid excessive fabrication costs of test apparatuses while maintaining repeatability and reproducibility of the test method results. These values given in parentheses are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3104-99(2005)

ASTM D3104-99(2005)

Standard Test Method for Softening Point of Pitches (Mettler Softening Point Method)

$30.00 $60.00

ASTM D6387-99(2005)

ASTM D6387-99(2005)

Standard Test Methods for Composition of Turpentine and Related Terpene Products by Capillary Gas Chromatography

$30.00 $60.00

ASTM E2448-05

ASTM E2448-05

Standard Test Method for Determining the Superplastic Properties of Metallic Sheet Materials

$29.00 $58.00

ASTM E2389-05

ASTM E2389-05

Standard Guide for Examination of Documents Produced with Liquid Ink Jet Technology (Withdrawn 2014)

$25.00 $50.00