Your shopping cart is empty!
ASTM International, 03/01/2018
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/03/2018
Pages:11
File Size:1 file , 430 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This guide provides information for the selection, care, and use of arc protective blankets for personnel protection.
1.2 This guide covers positioning and securing arc protective blankets (tested to Test Method F2676) and channeling the thermal, ballistic, and concussive forces generated by an arc flash event using arc protective blankets.
1.3 This guide describes the use of the arc protective blanket to maximize its protective effectiveness to workers exposed to energized electrical equipment where complete de-energizing of the work zone cannot be achieved or for low-risk exposures with sufficient arc flash incident energy to warrant secondary protective means in the event of an arc flash.
1.4 The values stated in SI units are to be regarded as the standard. See IEEE/ASTM SI-10.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Slag Cement for Use in Concrete and Mortars
$30.00 $60.00
Standard Test Method for Extraction and Derivatization of Vegetable Oils and Fats from Fire Debris and Liquid Samples with Analysis by Gas Chromatography-Mass Spectrometry
$29.00 $58.00
Standard Test Method for Determining Density of Structural Lightweight Concrete
$26.00 $52.00
Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series