Your shopping cart is empty!
ASTM International, 04/15/2022
Publisher: ASTM
File Format: PDF
$50.00$100.00
Published:15/04/2022
Pages:48
File Size:1 file , 1 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This specification covers the performance requirements for remote identification (Remote ID) of unmanned aircraft systems (UAS). Remote ID allows governmental and civil identification of UAS for safety, security, and compliance purposes. The objective is to increase UAS remote pilot accountability by removing anonymity while preserving operational privacy for remote pilots, businesses, and their customers. Remote ID is an enabler of enhanced operations such as beyond visual line of sight (BVLOS) operations as well as operations over people.
1.2''This specification defines message formats, transmission methods, and minimum performance standards for two forms of Remote ID: broadcast and network. Broadcast Remote ID is based on the transmission of radio signals directly from a UAS to receivers in the UAS'''s vicinity. Network Remote ID is based on communication by means of the internet from a network Remote ID service provider (Net-RID SP) that interfaces directly or indirectly with the UAS, or with other sources in the case of intent-based network participants.
1.3''This specification addresses the communications and test requirements of broadcast or network Remote ID, or both, in UAS and Net-RID SP systems.
1.4''Applicability:''
1.4.1''This specification is applicable to UAS that operate at very low level (VLL) airspace over diverse environments including but not limited to rural, urban, networked, network degraded, and network denied environments, regardless of airspace class.
1.4.2''This specification neither purports to address UAS operating with approval to use ADS-B or secondary surveillance radar transponders, nor does it purport to solve ID needs of UAS for all operations.
1.4.3''In particular, this specification does not purport to address identification needs for UAS that are not participating in Remote ID or operators that purposefully circumvent Remote ID.
1.5''The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.5.1''Units of measurement included in this specification:
''
m
meters
deg, ''
degrees of latitude and longitude, compass direction
s
seconds
Hz
Hertz (frequency)
dBm
decibel-milliwatts (radio frequency power)
ppm
parts per million (radio frequency variation)
Standard Test Method for Estimating Contribution of Environmental Tobacco Smoke to Respirable Suspended Particles Based on Solanesol
$30.00 $60.00
Standard Test Method for Portland-Cement Content of Hardened Hydraulic-Cement Concrete (Withdrawn 2019)
Standard Test Methods for Apparent Porosity, Apparent Specific Gravity, and Bulk Density of Graphite Electrodes
$25.00 $50.00
Standard Specification for Underground Precast Concrete Utility Structures
$26.00 $52.00
