Your shopping cart is empty!
ASTM International, 01/01/2022
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/01/2022
Pages:6
File Size:1 file , 98 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This specification covers requirements of wrought 35cobalt-35nickel-20chromium-10molybdenum alloy (UNS R30035) in the form of bar and wire, used for the manufacture of surgical implants. This alloy depends on combinations of work strengthening and aging to attain a variety of combinations of strength and ductility.
1.2''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other and values from the two systems shall not be combined.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Determination of Benzene and Total Aromatics in Denatured Fuel Ethanol by Gas Chromatography
$29.00 $58.00
Standard Guide for Filter Debris Analysis (FDA) Using Manual or Automated Processes
$32.00 $64.00
Standard Test Method for Laboratory Measurement of the Insertion Loss of Pipe Lagging Systems
Standard Practice for Evaluation of Surveillance Capsules from Light-Water Moderated Nuclear Power Reactor Vessels