• Your shopping cart is empty!

  • ASTM F606M-07e1

ASTM F606M-07e1

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets [Metric]

ASTM International, 09/01/2007

Publisher: ASTM

File Format: PDF

$32.00$65.00


Published:01/09/2007

Pages:15

File Size:1 file , 270 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of metric externally and internally threaded fasteners, washers, and rivets.

1.2 Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product shall specify the controlling testing requirements.

1.3 These test methods describe mechanical tests for determining the following properties:

Tests
 Section
For Externally Threaded Fasteners:
 3
Product Hardness
 3.1
Proof Load
 3.2.1
Method 1, Length Measurement
 3.2.3
Method 2, Yield Strength
 3.2.4
Method 3, Uniform Hardness
 3.2.5
Axial Tension Testing of Full Size Products
 3.4
Wedge Tension Testing of Full Size Products
 3.5
Tension Testing of Machined Test Specimens
 3.6
Total Extension at Fracture Test
 3.7
For Internally Threaded Fasteners:
 4
Product Hardness
 4.1
Proof Load
 4.2
Cone Proof Load Test
 4.3
For Washers and Direct Tension Indicators:
 5
General Requirements
 5.1
Through Hardened Washers
 5.2
Carburized Washers
 5.3
For Rivets:
 6
Product Hardness
 6.1
Test for Embrittlement of Metallic Coated Externally Threaded Fasteners
7
Test Method for Determining Decarburization and Carburization 8
Test Method for Measuring Compression Loads (All Finishes) on Direct Tension Indicators Covered by Test Method F 959M
Annex A1

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of all of the users of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1 - These test methods are the metric companion of Test Methods F 606.

More ASTM standard pdf

ASTM C907-03(2008)

ASTM C907-03(2008)

Standard Test Method for Tensile Adhesive Strength of Preformed Tape Sealants by Disk Method

$26.00 $52.00

ASTM C875-98(2008)

ASTM C875-98(2008)

Standard Specification for Asbestos-Cement Conduit

$26.00 $52.00

ASTM D5329-09

ASTM D5329-09

Standard Test Methods for Sealants and Fillers, Hot-Applied, for Joints and Cracks in Asphaltic and Portland Cement Concrete Pavements

$30.00 $60.00

ASTM C1570-03(2009)

ASTM C1570-03(2009)

Standard Test Method for Wind Resistance of Concrete and Clay Roof Tiles(Air Permeability Method)

$26.00 $52.00