Your shopping cart is empty!
ASTM International, 11/01/2013
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/11/2013
Pages:17
File Size:1 file , 270 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of metric externally and internally threaded fasteners, washers, and rivets.
1.2 Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product shall specify the controlling testing requirements.
1.3 These test methods describe mechanical tests for determining the following properties:
Tests
Section
For Externally Threaded Fasteners:
3
Product Hardness
3.1
Proof Load
3.2.1
Method 1, Length Measurement
3.2.3
Method 2, Yield Strength
3.2.4
Method 3, Uniform Hardness
3.2.5
Axial Tension Testing of Full Size Products
3.4
Wedge Tension Testing of Full Size Products
3.5
Tension Testing of Machined Test Specimens
3.6
Total Extension at Fracture Test
3.7
For Internally Threaded Fasteners:
4
4.1
4.2
Cone Proof Load Test
4.3
For Washers and Direct Tension Indicators:
5
General Requirements
5.1
Through Hardened Washers
5.2
Carburized Washers
5.3
For Rivets:
6
6.1
Test for Embrittlement of Metallic Coated Externally Threaded Fasteners
7
Test Method for Determining Decarburization and Carburization
8
Test Method for Measuring Compression Loads (All Finishes) on Direct Tension Indicators Covered by Test Method F959M
Annex A1
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of all of the users of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Test Methods for Rubber Compounding Material-Zinc Oxide
$22.00 $44.00
Standard Classification System for Copolymers of Vinylidene Fluoride (VDF) with Other Fluorinated Monomers
$38.00 $76.00
Standard Test Method for Sieve Analysis of Surfacing for Asphalt Roofing Products
$25.00 $50.00
Standard Specification for Steel Sheet Piling
$26.00 $52.00
