• Your shopping cart is empty!

  • ASTM F736-17(2023)

ASTM F736-17(2023)

Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight

ASTM International, 01/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/01/2023

Pages:6

File Size:1 file , 290 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the energy required to initiate failure in monolithic polycarbonate sheet material under specified conditions of impact using a free falling weight.
1.2 Two specimen types are defined as follows:
1.2.1 Type A consists of a flat plate test specimen and employs a clamped ring support.
1.2.2 Type B consists of a simply supported three-point loaded beam specimen (Fig. 1) for use with material which can not be failed using the Type A specimen. For a maximum drop height of 6.096 m (20 ft) and a maximum drop weight of 22.68 kg (50 lb), virgin polycarbonate greater than 12.70 mm (1/2 in.) thick will require use of the Type B specimen.
Note 1: See also ASTM Methods: D1709, D2444 and D3029.
FIG. 1 Type B Specimen Geometry and Loading
Type B Specimen Geometry and Loading Type B Specimen Geometry and Loading
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exception-The inch-pound units in parentheses are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statement, See Section 7.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM A855/A855M-98

ASTM A855/A855M-98

Standard Specification for Zinc-5% Aluminum-Mischmetal Alloy-Coated Steel Wire Strand

$29.00 $58.00

ASTM D4093-95(2010)

ASTM D4093-95(2010)

Standard Test Method for Photoelastic Measurements of Birefringence and Residual Strains in Transparent or Translucent Plastic Materials

$33.00 $67.00

ASTM A325M-14

ASTM A325M-14

Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength (Metric) (Withdrawn 2016)

$30.00 $60.00

ASTM E1111/E1111M-14

ASTM E1111/E1111M-14

Standard Test Method for Measuring the Interzone Attenuation of Open Office Components

$32.00 $64.00