Your shopping cart is empty!
ASTM International, 12/10/2001
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:10/12/2001
Pages:7
File Size:1 file , 89 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers requirements for poly(vinyl chloride) (PVC) profile sewer pipe and fittings with integral bell and elastomeric seal joints or plain end pipe with couplings in sizes (4 to 48 in.) based on a controlled inside diameter.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazard caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1 - Pipe and fittings produced to this specification should be installed in accordance with Practice D 2321.
Standard Specification for Asphalt Roll Roofing (Glass Felt) Surfaced with Mineral Granules
$30.00 $60.00
Standard Test Method for Abrasion Resistance of Stone Subjected to Foot Traffic
$27.00 $54.00
Standard Practice for Determining Relative Spectral Correction Factors for Emission Signal of Fluorescence Spectrometers
$28.00 $57.00
Standard Test Method for Determining Impact Resistance of New Low Slope Roof Membranes Using Steel Balls (Z8295Z)