Your shopping cart is empty!
ASTM International, 03/01/2013
Publisher: ASTM
File Format: PDF
$29.00$58.00
Published:01/03/2013
Pages:5
File Size:1 file , 86 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt.
1.2 Four types of direct tension indicators in nominal diameter sizes 1/2 through 11/2 in. are covered:
1.2.1 Type 325-direct tension indicators for use with Specification A325 Type 1 bolts or F or F1852 assemblies.
1.2.2 Type 325-3-direct tension indicators for use with Specification A325 Type 3 or F1852 Type 3 assemblies.
1.2.3 Type 490-direct tension indicators for use with Specification A490 Type 1 bolts or F2280 assemblies.
1.2.4 Type 490-3-direct tension indicators for use with Specification A490 Type 3 F2280 Type 3 assemblies.
1.3 Direct tension indicators are intended for installation under either a bolt head or a hardened washer. (See Research Council on Structural Connections: Specification for Structural Joints Using ASTM A325 or A490 Bolts.)
1.4 This specification provides for furnishing Types 325-3 and 490-3 to a Chemical Composition Requirement or a Corrosion Resistance Index (CRI) at the suppliers option.
1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 The following precautionary statement pertains only to the test method portions, Section 12 and Appendix X1 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Design and Manufacture of Reciprocating Spark Ignition Engines for Light Sport Aircraft
$22.00 $44.00
Standard Test Method for Nonvolatile Residue of Solvent Extract from Aerospace Components (Using Flash Evaporator)
$26.00 $52.00
Standard Specification for Stainless Steel Bars and Shapes
$29.00 $58.00
Standard Test Method for Foaming Tendencies of Engine Coolants in Glassware
$21.00 $42.00
