1.1 This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments (1, 2).2 Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range (3-5). Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.
1.2 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard (exceptions below).
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
More ASTM standard pdf
ASTM C359-07
Standard Test Method for Early Stiffening of Hydraulic Cement (Mortar Method)
$26.00 $52.00
ASTM D5031-96
Standard Practice for Enclosed Carbon-Arc Exposure Tests of Paint and Related Coatings
$29.00 $58.00
ASTM C1356-07
Standard Test Method for Quantitative Determination of Phases in Portland Cement Clinker by Microscopical Point-Count Procedure
$30.00 $60.00