Your shopping cart is empty!
ASTM International, 11/01/2021
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/11/2021
Pages:4
File Size:1 file , 180 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers accelerated procedures for simultaneously determining comparative characteristics of coating systems applied to steep pipe exterior for the purpose of preventing or mitigating corrosion that may occur in underground service where the pipe will be in contact with natural soils and will receive cathodic protection. They are intended for use with samples of coated pipe taken from commercial production and are applicable to such samples when the coating is characterized by function as an electrical barrier.
1.2''This test method is intended to facilitate testing of coatings where the test cell is cemented to the surface of the coated pipe specimen. This is appropriate when it is impractical to submerge or immerse the test specimen as required by Test Methods G8, G42, or G80. Coating sample configuration such as flat plate and small diameter pipe may be used, provided that the test procedure remains unchanged.2
1.3''This test method allows options that must be identified in the report.
1.4''The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Terminology Relating to Textiles
$55.00 $111.00
Standard Specification for Joint Compound and Joint Tape for Finishing Gypsum Board
$26.00 $52.00
Standard Test Method for Determining the Penetration of Chloride Ion into Concrete by Ponding
Standard Practice for Fractography and Characterization of Fracture Origins in Advanced Ceramics
$47.00 $94.00