• IEC 60317-15 Ed. 3.1 b:2010

IEC 60317-15 Ed. 3.1 b:2010

Specifications for particular types of winding wires - Part 15: Polyesterimide enamelled round aluminium wire, class 180 CONSOLIDATED EDITION

International Electrotechnical Commission, 06/16/2010

Publisher: IEC

File Format: PDF

$41.00$82.00


Published:16/06/2010

Pages:17

File Size:1 file , 880 KB

Note:This product is unavailable in Ukraine, Russia, Belarus

IEC 60317-15:2004+A1:2010 Specifies the requirements of enamelled round aluminium winding wire of class 180 with a sole coating based on polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. Class 180 is a thermal class that requires a minimum temperature index of 180 and a heat shock temperature of at least 200 °C. The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved. The range of nominal conductor diameters covered by this standard is as follows:
- grade 1: 0,400 mm up to and including 1,600 mm;
- grade 2: 0,400 mm up to and including 5,000 mm.
The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-3. The main changes with respect to the previous edition are listed below:
- new requirements for appearance, Subclause 3.2, added;
- springiness test, Clause 7, determined to be inappropriate;
- cut-through test, Clause 10, determined to be inappropriate;
- high temperature failure test, Clause 22, deleted;
- new pin hole test, Clause 23, added

This publication is to be read in conjunction with IEC 60317-0-3:2008.

This consolidated version consists of the third edition (2004) and its amendment 1 (2010). Therefore, no need to order amendment in addition to this publication.

More IEC standard pdf

IEC 61169-1 Ed. 2.0 en:2013

IEC 61169-1 Ed. 2.0 en:2013

Radio frequency connectors - Part 1: Generic specification - General requirements and measuring methods

$151.00 $303.00

IEC 60745-2-9 Amd.1 Ed. 2.0 b:2008

IEC 60745-2-9 Amd.1 Ed. 2.0 b:2008

Amendment 1 - Hand-held motor-operated electric tools - Safety - Part 2-9: Particular requirements for tappers

$6.00 $13.00

IEC 61747-10-1 Ed. 1.0 b:2013

IEC 61747-10-1 Ed. 1.0 b:2013

Liquid crystal display devices - Part 10-1: Environmental, endurance and mechanical test methods - Mechanical

$47.00 $95.00

IEC 60793-2-60 Ed. 1.0 en:2008

IEC 60793-2-60 Ed. 1.0 en:2008

Optical fibres - Part 2-60: Product specifications - Sectional specification for category C single-mode intraconnection fibres

$70.00 $141.00