IEC 60695-2-11 Ed. 3.0 b:2021

Fire hazard testing - Part 2-11: Glowing/hot-wire based test methods - Glow-wire flammability test method for end-products (GWEPT)

International Electrotechnical Commission, 10/01/2021

Publisher: IEC

File Format: PDF

$47.00$95.00


Published:01/10/2021

Pages:36

File Size:1 file , 1.5 MB

Note:This product is unavailable in Ukraine, Russia, Belarus

This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard.
This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard analysis, the flammability aspects and the flame spreading to other products are not covered by this document.
This basic safety publication focusing on safety test method(s) is primarily intended for use by technical committees in the preparation of safety publications in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51.
One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications in the preparation of its publications.

More IEC standard pdf

IEC 60071-SER Ed. 1.0 b:2023

IEC 60071-SER Ed. 1.0 b:2023

Insulation co-ordination - ALL PARTS

$879.00 $1,759.00

IEC 60115-2-10 Ed. 1.0 en:2023

IEC 60115-2-10 Ed. 1.0 en:2023

Fixed resistors for use in electronic equipment – Part 2-10: Blank detail specification: Low-power film resistors with leads for through-hole assembly on circuit boards (THT), for general electronic equipment, classification level G

$164.00 $329.00

IEC 62087-2 Ed. 2.0 b:2023

IEC 62087-2 Ed. 2.0 b:2023

Audio, video, and related equipment - Determination of power consumption - Part 2: Signals and media

$139.00 $278.00

IEC 60115-2 Ed. 4.0 en:2023

IEC 60115-2 Ed. 4.0 en:2023

Fixed resistors for use in electronic equipment – Part 2: Sectional specification: Low-power film resistors with leads for throughhole assembly on circuit boards (THT)

$227.00 $455.00