IEC 62329-1 Ed. 1.0 b:2005

Heat shrinkable moulded shapes - Part 1: Definitions and general requirements

International Electrotechnical Commission, 11/21/2005

Publisher: IEC

File Format: PDF

$25.00$51.00

Description

Published:21/11/2005

Pages:18

File Size:1 file , 200 KB

Note:This product is unavailable in Ukraine, Russia, Belarus

IEC 62329-1:2005 is applicable to heat shrinkable moulded shapes in a range of configurations and materials suitable for insulation, environmental sealing, mechanical protection and strain relief for connector/cable terminations and multi-way transitions. It specifies the design and dimensions, test methods, material requirements and compatibility performance. The most commonly available shapes are as shown in Annex A. Keywords: heat shrinkable moulded shapes

More IEC standard pdf

IEC 60335-2-106 Ed. 1.0 b:2007

Household and similar electrical appliances - Safety - Part 2-106: Particular requirements for heated carpets and for heating units for room heating installed under removable floor coverings

$129.00 $259.00

IEC 60169-24 Ed. 1.0 b CORR1:1995

Corrigendum 1 - Radio-frequency connectors - Part 24: Radio-frequency coaxial connectors with screw coupling, typically for use in 75 ohm cable distribution systems (Type F)

$102.00 $205.02

IEC 61237-3 Ed. 1.0 b COR.1:1995

Corrigendum 1 - Broadcast video tape recorders - Methods of measurement - Part 3: Electrical measurements for analogue component video signals

$149.00 $299.11

IEC 61462 Ed. 1.0 b:2007

Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with rated voltage greater than 1 000 V - Definitions, test methods, acceptance criteria and design recommendations

$164.00 $329.00